Lab Metrologist

The Metrologist reports to and supports the Quality Department while working closely with Engineering regarding measurement methods, equipment selection, calibration, measurement uncertainty, and inspection system capability.

The Metrologist will also perform inspections to verify compliance and work closely with Engineering to develop fixtures capable of multiple measurements at one time to both speed up the process and provide less variation of results from person to person.

• Establish appropriate measurement methods for dimensional and functional characteristics.
• Determine whether inspection equipment has sufficient accuracy for the required measurement.
• Assist others in selecting appropriate measurement equipment for specific drawing characteristics.
• Evaluate measurement resolution, accuracy, repeatability, and capability.
• Develop and maintain measurement procedures and work instructions.
• Support the selection and qualification of new inspection equipment.

• Establish inspection requirements for fixed and variable gauges.
• Establish calibration or verification intervals for inspection fixtures.
• Develop gauge verification procedures.
• Determine appropriate acceptance criteria for gauge verification.
• Ensure fixtures used to determine product conformity are properly identified and controlled.
• Support the design and qualification of inspection fixtures.

• Provide technical support to inspectors regarding measurement methods.
• Train inspection personnel in proper use of measurement equipment.
• Develop standardized measurement techniques for difficult or critical characteristics.
• Assist with inspection problems involving:
• Tight dimensional tolerances
• Geometric tolerances
• Surface finish
• Angles
• Radii
• Profiles
• Concentricity/runout
• Flatness
• Perpendicularity
• Position
• Contour measurements
• Assist in determining the appropriate inspection method when the drawing does not clearly specify a measurement technique.

• Support MRB and NCR investigations involving measurement equipment.
• Investigate discrepancies caused by measurement-system problems.
• Perform root-cause analysis of calibration failures.
• Evaluate historical measurements when equipment is found out of tolerance.
• Establish containment actions when measurement-system accuracy is questionable.
• Recommend corrective and preventive actions.
• Trend calibration failures to identify recurring problems.

• Associate's or Bachelor's degree in Metrology, Engineering, Manufacturing Technology, Quality Engineering, or a related technical field; equivalent experience may be accepted.
• 3–7 years of experience in dimensional metrology, calibration, inspection, or aerospace manufacturing.
• Strong understanding of dimensional measurement principles.
• Ability to read and interpret engineering drawings and GD&T.
• Experience with calibration systems and measurement equipment.
• Ability to determine appropriate measurement equipment based on tolerance and application.
• Strong mathematical and analytical skills.
• Strong documentation and recordkeeping skills.