Quality Engineer

• Interpret engineering drawings, GD&T callouts, and technical data packages to define inspection requirements and acceptance criteria

• Develop and validate inspection methods for machined components, including in-process and final inspection strategies

• Select and apply appropriate metrology tools (CMM, optical systems, surface plate instruments, handheld gages, etc.)

• Provide shop floor support to machinists and inspectors to ensure understanding of dimensional and geometric requirements

• Troubleshoot dimensional issues using measurement data, machining knowledge, and root cause analysis

• Serve as a subject matter expert in GD&T application and interpretation

• Review of drawings and specifications for inspection feasibility

• Lead and schedule DCMA source inspections

• Ensure accuracy and reliability of inspection equipment through Measurement System Analysis (MSA) & Gage R&R’s

• Evaluate gaging strategies for complex features and tight tolerances

• Develop work instructions and inspection plans that clearly define measurement methods and acceptance criteria 

• Support CMM programming validation and inspection method optimization

• Apply statistical methods and process monitoring to reduce variation in machining processes (SPC)

• Lead or support PFMEA activities with emphasis on machining and inspection risks

• Drive process improvements based on nonconformance trends and inspection data

• Partner with manufacturing to improve first-pass yield and reduce scrap/rework

• Participate in Material Review Board (MRB) activities with emphasis on technical disposition and dimensional analysis

• Perform root cause analysis on dimensional and process-related defects

• Lead or support Corrective and Preventive Actions (CAPA) through implementation and verification

• Analyze recurring issues to drive preventive actions at the process level

• Evaluate supplier machining and inspection capabilities with focus on dimensional control

• Review supplier inspection results and measurement method correlation

• Support resolution of supplier nonconformances and corrective actions

• Drive improvement in supplier quality performance related to precision machining

• Ensure compliance with ISO 9001 and internal QMS procedures

• Support internal audits and continuous improvement of quality processes and documentation

• Contribute to development of inspection standards, work instructions, and best practices

• Support customer audits, source inspections, and regulatory visits as needed

This position requires use of information or access to hardware subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR.  Visa sponsorship is not available for this position.

• ASQ certification (CQE, CQA, or similar)

• Experience with Lean Six Sigma methodologies

• Familiarity with ERP systems and quality management software

• Knowledge of industry-specific regulations and standards

• Knowledge of PCDMIS programming

• Exceptional attention to detail and commitment to quality

• Strong leadership and interpersonal skills

• Ability to work effectively in a fast-paced, dynamic environment

• Demonstrated project management abilities

• Proactive approach to identifying and resolving quality issues

• Willingness to continuously learn and adapt to new technologies and methodologies

• Work is primarily performed in an office environment with frequent visits to the manufacturing floor

• May require occasional travel for supplier audits or inspections

• Must be able to wear all required PPE in designated areas

• Work may involve standing or walking on the manufacturing floor for extended periods

• May require occasional lifting of up to 25 lbs